VPC Rudder Pedals - Damper Kit - User Manual

Modified on Mon, 5 Feb at 5:47 AM

What's in the Box:

  • 1x Damper

  • 1x Bracket

  • 1x Coupling Nut

  • 2 x Screw ISO 7380 M8x25 A2
  • 2 x Washer DIN 125A 8,4 PA6 
  • 1 x Nut DIN 985 M8 A2


Damper installation


 

Tools required:

- Phillips Screwdriver (NOT INCLUDED)- Wrench 8/10/13 mm (NOT INCLUDED)

- H5 Hex key (NOT INCLUDED)

H4 Hex key (NOT INCLUDED)  

1. Install the damper bracket in the correct position using the highlighted screw.

2. Unscrew the selected nuts.

3. Screw in the highlighted screws by 3 turns to increase the height of the threaded part for installing the bracket.

4. Install the bracket and secure it with the same nuts.

5. Remove the highlighted screw.

6. Screw the coupling nut into the hole.

7. Install the damper and secure it with screws and nuts.

Important! The damper must not limit the pedal travel. In case of discrepancy, go back to point 1 and adjust the position of the bracket.


8. Adjust the force (counterclockwise - decrease the force; clockwise - increase the force).


Troubleshooting

If you are experiencing any issues or have further questions, please create a support ticket and our support team will assist you ASAP!

https://support.virpil.com/


Regards,

VIRPIL Controls Team



Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article